Need help?Do you have a question about the Toshiba Compliant Manager BMS-CM1280TLE and is the answer not in the manual?
Diagrams showing the physical dimensions of the unit and mounting hole locations.
Details on connecting the Compliant Manager to external equipment and input/output terminals.
Recommended materials and specifications for signal lines and power lines.
Setting the operating mode to either central control or remote control.
Selecting simultaneous or arbitrary ranges of lines and groups for control.
Configuration settings for DIP-SW1, covering main/sub selection and control group.
Configuration settings for DIP-SW2, covering timer input, buzzer, and indication.
Configuration settings for DIP-SW3, including synchronization and fire alarm input.
Steps required before setting central control addresses, including power and communication.
Procedures for setting addresses using wired remote controller, manual, or automatic methods.
Automatically assigns central control addresses in ascending order of unit number.
Procedure to check for and identify duplicate central control address errors.
Steps to correct duplicate addresses found during the checking process.
Procedure for changing return-back time and temperature settings using CODE No.
Steps to confirm unit recognition and central control address settings.
Procedure for conducting a test run on the air conditioners themselves.
To Next Page
General