Programming Channel Memory
The channel memory is the list of TV channel numbers your TV will stop on when you press the
CHANNEL • or • button.
First, use the W/CABLE and CH PROGRAM functions to preset all active channels in your area.
If necessary, arrange the preset channels with the ADD/ERASE functions so that you can tune into
only desired channels.
oop 0
MENU
1
2
3
Press POWER to turn on the TV.
Press MENU (then • or •
on Remote) repeatedly until
"W/CABLE" in the Set up
menu is displayed in
purple.
TVJCAnLE T_CAnLE
kOVEEA• I SELECTI_ • b
Press • (<) or • (>) until
the mode that I
corresponds to your TV I "__"__:_'.Tvc_._
signal system is displayed , i_ _ {_,
in purple. _'_ _ _:, _:__'
TV; TV broadcasts
signals. .0_1, ,i s_c_l, ,.i
(VHF channels 2
through 13 and UHF channels 14 through
69)
CABLE: Cable TV signals.
(Cable channels 1 through 125)
Menu
POWER
Channel
1 Press MENU (then • or •
on Remote) repeatedly
until "CH PROGRAM" in
the Set up menu is
displayed in purple.
2
CHANNEL
•/v
Menu
Press • (<) or • (>) to start
channel programming.
The TV will automatically
cycle through all the TV or
CABLE channels
depending on the mode
selected, and store active
channels in the channe_
memory,
CH p_
MOVE_A'_1 SELECTI,_ b I
CH pROGRAM
TV 15
!"
C_4pLET£D
TV 4
3
When channel
programming is complete,
you will see the message
at the right.
4 Press CHANNEL • or • to make sure the channel
programming has been done properly.
8
To Next Page
Loading...