Toshiba D-RW2SU - Cabinet Disassembly Instructions

1-5-1 E7A70DC
CABINET DISASSEMBLY INSTRUCTIONS
1. Disassembly Flowchart
This flowchart indicates the disassembly steps to gain
access to item(s) to be serviced. When reassembling,
follow the steps in reverse order. Bend, route, and
dress the cables as they were originally.
2. Disassembly Method
Note:
(1) Identification (location) No. of parts in the figures
(2) Name of the part
(3) Figure Number for reference
(4) Identification of parts to be removed, unhooked,
unlocked, released, unplugged, unclamped, or
desoldered.
P = Spring, L = Locking Tab, S = Screw,
CN = Connector
* = Unhook, Unlock, Release, Unplug, or Desolder
e.g. 2(S-2) = two Screws (S-2),
2(L-2) = two Locking Tabs (L-2)
(5) Refer to “Reference Notes.”
Reference Notes
1. CAUTION 1: Locking Tabs (L-1) and (L-2) are
fragile. Be careful not to break them.
NOTE: BOARD MEANS PRINTED CIRCUIT BOARD.
ID/
Loc.
No.
Part
Removal
Fig.
No.
Remove/*Unhook/
Unlock/Release/
Unplug/Desolder
Note
[1] COVER TOP D1 7(S-1) ---
[2]
PA NE L
FRONT
D2 *6(L-1), *3(L-2) 1
[3]
DVD
MECHANISM
& DVD MAIN
BOARD
ASSEMBLY
D3
4(S-2), *CN101,
*CN701,
LOCKING CARD
SPACERS,
MAIN SHEET
---
[4]
BOARD
SWITCH
D4
(S-3), S PLATE
EARTH, Desolder
---
[5]
BOARD
HOLDER
D4 2(S-4) ---
[6]
PA NE L
REAR
D5 2(S-5), 6(S-6) ---
[7]
BOARD
POWER
D5
3(S-7), HEAT SINK
EARTH PLATE
---
↓
(1)
↓
(2)
↓
(3)
↓
(4)
↓
(5)
[1] COVER TOP
[2] PANEL FRONT
[3] DVD MECHANISM & DVD MAIN BOARD ASSEMBLY
[4] BOARD SWITCH
[5] BOARD HOLDER
[6] PANEL REAR
[7] BOARD POWER
[1] COVER TOP
(S-1)
(S-1)
(S-1)
Fig. D1