LQ500
No. EJL-106A
Ordering Information
When ordering the LQ500, refer to Table 4. Type
Specification Code. An entry must be made for each of
the columns.
The following items must also be specified:
1. Fluid characteristics:
• Type of material to be measured
• Density (consistency) (max., normal, min.)
• Temperature (max., normal, min.)
• Pressure (max., normal, min.)
• Conductivity (max., normal)
2. Measurement range
3. Tag number (specify “None” if not needed)
4. Hand-held terminal Required or not
(Refer to Table 5 below.)
5.Other specific items
To Next Page
Loading...
