1.GENERAL PRECAUTIONS
General Precautions 19
Large Capacity Feeder
Before moving the equipment with the Desk installed, remove the front stabilizer. Be sure to reinstall it
after the equipment has been moved.
e-STUDIO5560C/6560C/6570C
There are 4 adjusters (stoppers) at the bottom of the equipment (2 in the rear, 2 in the front). After
moving/installing the equipment, be sure to turn and lower the adjusters, and then fix them firmly on the
floor.
Before moving the equipment, turn and raise the adjusters.
Do not install the equipment by yourself or try to move it once it has been installed. This could result in an
injury or damage to the device. Contact your service representative if the equipment needs to be installed or
moved.
Removing the stabilizer Installing the stabilizer
To Next Page
Loading...
