Unified Controller nv series G3 I/O Adapter (GA932) Module Instruction Manual
ix
...1
1.1 Functions and Characteristics of GA932 Module
········· 2
1.1.1 System configuration ············································· 4
1.1.2 Data input/output with G3 I/O module ························ 6
1.1.3 Online map/Online status for G3 I/O module ··············· 7
1.2 Names and Functions of the Parts
······························· 8
1.2.1 Names of the parts ··············································· 8
1.2.2 Functions of the parts ············································ 9
2.1 Types of I/O Base Units
············································· 13
2.2 Installing / Removing the Module
······························· 14
2.3 TC-net I/O Loop Wiring
·············································· 17
2.4 Replacing the Module
················································ 19
2.5 Handling the RUN Signal (RUN contact) of G3 I/O
······ 20
3.1 Switch Setting
··························································· 22
3.1.1 Operation mode setting switch (MODE) ··················· 22
3.1.2 Maintenance switch (MAINT) ································ 23
3.1.3 Node No. setting switches ···································· 23
3.2 Setting with the Engineering Tool
······························ 24
3.2.1 I/O Node registration ··········································· 25
3.2.2 Association G3 I/O adapter and I/O Node Number
and setting I/O loop scan speed ····························· 27
3.2.3 G3 I/O and I/O module registration ························· 30
3.2.4 I/O variables registration ······································ 33
...35
4.1 Checking the Switch before Startup
·························· 36
4.2 Startup
······································································ 36
4.3 Shutdown
·································································· 37