2-2-l. Function PCB Removal
1.
Follow the procedures for removing the bottom cover,
the top cabinet and the panel front. (See Fig.1 to
3)
2. Release five
(5)
tabs on the function board.
3. Release
connector(CN701)
gently with using the Driver
as shown Fig. 4
2-2-3. Main circuit board Removal
Fig. 4 Function PCB Removal
2-2-2. Deck Ass’y Removal
1.
Follow the procedures for removing the bottom cover,
top cabinet and the front panel
ass'y
(See Fig.1 to
3)
2. Remove four
(4)
screws from the bottom and top of the
deck ass’y.
3. Remove two
(2)
screws from the bottom of the frame.
4. Lift the deck ass’y upward to remove.
OREMOVE
FOUR
SCREWS
1 .Follow the procedures for removing Fig. 1 to 6
2.Release
three
(3)
tabs from the frame.
3.Pull
out the main circuit board in the direction of the
arrow.
RELEASE THREE
TABS
Fig. 6 Main Circuit Board Removal
Fig. 5 Deck ass’y Removal
2-2
To Next Page
Loading...
