MR-3018/3020/3021/3022 © 2005 - 2011 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
5 - 2
[B] Adjustment
If the pins cannot be fitted into the holes, perform the adjustment according to the following procedure.
(3) Close the RADF and check if the positioning
pins fit the holes on the RADF.
Fig. 5-3
(1) Remove the right-hand hinge screw at the
rear side.
Fig. 5-4
(2) Remove the bracket on the left-hand hinge.
(MR-3021/3022 only)
Fig. 5-5
09/05
To Next Page
