OPERATION
INSTRUCTION FOR USE
Ŷ Wait until " " sign is
normally on display.
Ŷ If the connection fails, the error
code “N0~N5” is displayed for
3 seconds. Other errors show
“FFFF” for 30 seconds. Please
try the link again.
Possible Cause
Error
N1
The module cannot be found.
The connection to the router failed and the router signal was poor.
Router Wi-Fi could not be found.
The connection to the router failed. The Wi-Fi password is incorrect.
Connection to router failed, good signal and no password error reported.
N0
N2
N3
N4
N5
Connection to router successfully but the server could not be
connected overtime. (including domain name resolution error)
When an error message "N " appears on the display, please check the following table.
*
14. Turn to WLAN setting page and
connect to
Using 12345678 as pass-code.
toshiba_b0_xxxx
15. Go back to 5TNBSUMJGF.
toshiba_b0_
toshiba_b0_
To Next Page
Loading...
