EN-15
Cleaning the cooking compartment and putting the turntable in place.
For new installations, make sure all packaging and shipping tape has been removed from the
turntable shaft.
Before using the appliance to prepare food for the first time, you will need to put the turntable in
place correctly. You must clean the cooking compartment and accessories.
TURNTABLE INSTALLATION
1
2
3
SETTING UP YOUR OVEN
How to put the turntable in place:
1. Place the turntable ring assembly
into the recess
in the cooking compartment.
2. Place the glass turntable
on the turntable ring assembly .
Fit the raised, curved lines in the center of the glass turntable
bottom between the three spokes of the shaft.
Make sure that the glass turntable
engages in the
turntable shaft
in the center of the cooking
compartment floor. The rollers on the shaft should fit inside
the turntable bottom ridge.
• Never use the appliance without the turntable. Make sure that it is
properly engaged. The turntable can turn clockwise or anti-clockwise.
• Never place the glass
turntable upside down. The glass turntable should
never be restricted.
• Both glass turntable
and turntable ring assembly must always be used
during cooking.
• All food and containers of food are always placed on the glass turntable
for cooking.
• Never restrict the movement of the turntable.
• If glass turntable or turntable ring assembly cracks or breaks, contact
your
nearest authorized service center.
NOTE
To Next Page
Loading...
