User’s Manual 7-9
PORTÉGÉ M700
Ending the BIOS Setup Program Halfway
The configuration settings can be terminated halfway without saving any of
the changes made by following the steps detailed below:
1. Press the ESC key - the Exit without saving? (Y/N) prompt to
be displayed at the bottom of the screen.
2. Press the Y key - the BIOS setup application will exit and the computer
will automatically restart.
Supervisor Password
This setting, which is displayed on the first page of the setup screen, Allows
you to register a Supervisor Password of the computer.
Core Multi - Processing
The Core Multi-Processing sets the CPU operating mode.
Enabled is Dual Core mode.
Disabled is Single Core mode.
Not Registered Supervisor Password has not been registered
(Default).
Registered Supervisor Password has been registered.
The User Password and Supervisor Password configured in BIOS SETUP
can also be changed or deleted using the TOSHIBA Password Utility.
When unable to perform the following operations, use the TOSHIBA
Password Utility to change the configuration or delete the Supervisor
Password.
■ Configuration changes in the BIOS Setup Program
■ Configuration changes in the HW Setup utility
■ Selection of the startup device during computer recovery
Enabled Enables Core Multi - Processing functions
(Default).
Disabled Disables Core Multi - Processing functions.
To Next Page
Loading...
