User’s Manual 7-13
PORTÉGÉ M700
SATA Controller Mode
This feature sets the SATA Controller Mode.
USB Sleep and Charge function
This section describes the settings for “USB Sleep and Charge function”.
For more information, please refer to the USB Sleep and Charge function
section in Chapter 3, Hardware, Utilities and Options.
The default setting in BIOS Setup is [Disabled]. Changing the setting to
[Enabled] enables the use of this function.
There are two modes, Mode-1 and Mode-2 in [Enabled]. For normal use,
set the setting to Mode-1.
The SATA Controller Mode is supported with some models.
AHCI Sets AHCI which is the mode for Windows Vista
®
(Default).
Compatibility Sets the mode for legacy OS. Use this mode
when the driver corresponding to AHCI is not
used.
If the function does not work with Mode-1 setting, change it to Mode-2.
Some external devices may not be able to use this function in either mode.
When this happens, change the setting to [Disabled].
Enabled (Mode-1) Enables USB Sleep and Charge function.
Enabled (Mode-2) Enables USB Sleep and Charge function.
Disabled Disables USB Sleep and Charge function
(Default).
To Next Page
Loading...
