29
Mobile computing
5.375 x 8.375 ver 3.1
5 Slide the battery release lock/unlock switch down into the
unlocked position.
(Sample Illustration) Unlocking the battery release lock
6 Slide the battery release latch to the right to release the battery.
7 Lift the outer edge of the discharged battery, and then pull it up
and out of the computer.
(Sample Illustration) Removing the battery
If the battery is leaking or its case is cracked, put on protective gloves
to handle it, and discard it immediately. Always dispose of used battery
packs in compliance with all applicable laws and regulations. Put
insulating tape, such as cellophane tape, on the electrode during
transportation to avoid a possible short circuit, fire or electric shock.
Failure to do so could possibly result in serious injury.
Inserting a charged battery
To insert a battery:
1 Wipe the terminals of the charged battery with a clean cloth to
ensure a good connection.
2 Insert the charged battery into the slot, pressing down until the
latch clicks.
The battery pack has been designed so that you cannot install it
with reverse polarity.
To Next Page
Loading...
Need help?
General