To Next PageTo Next Page
Need help?Do you have a question about the Toshiba RAS-10UAH-E and is the answer not in the manual?
General| Cooling Capacity | 2.5 kW |
|---|---|
| Heating Capacity | 3.2 kW |
| Energy Efficiency Ratio (EER) | 3.21 |
| Power Supply | 220-240V, 50Hz |
| Refrigerant | R410A |
| Weight (Indoor Unit) | 9 kg |
| Noise Level (Outdoor Unit) | 50 dB(A) |
| Type | Split System |
Critical safety instructions regarding immediate hazards and general warnings.
Safety advice for installation, operation, and handling the unit to prevent damage or injury.
Specific warnings and precautions for the installation process of the air conditioner.
Important safety guidelines to follow during the operation of the air conditioner.
Identification and list of parts for both the outdoor and indoor units.
Names and functions of the indicators and controls found on the indoor unit's display panel.
Instructions for operating the air conditioner using the temporary button.
Details on the signal transmission and primary buttons of the remote control.
Explanation of buttons for selecting operation modes and fan speeds.
Functions of timer, reserve, cancel, and other operational buttons on the remote.
Detailed explanation of all indications and symbols shown on the remote control display.
Instructions for loading, replacing, and maintaining batteries in the remote control.
Procedure for setting and adjusting the clock on the remote control.
Guidance on preparing and installing the air filters for the unit.
Precautions and warnings for safe and effective use of the remote control.
Recommendations for placing the remote control for best signal reception.
Instructions for installing the remote control holder on a wall or pillar.
Details on the automatic operation mode based on room temperature.
Explanation of the 'A' mode for automatic cooling, heating, or fan operation.
Instructions for operating the unit in Cool, Heat, or Fan Only modes.
Guidance on using the Dry operation mode for dehumidification.
Description of the high power mode for rapid cooling or heating.
Setting and using the ON and OFF timer functions for scheduled operation.
Instructions for setting combined ON and OFF timers for daily or sequential operation.
Procedure for canceling any set timer operations.
Explanation of how the clock and timer settings are displayed.
How to save frequently used operation settings using the MEMO button.
How to recall and activate memorized settings using the PRESET button.
Instructions for adjusting the vertical air flow direction using the remote control.
Manual adjustment procedure for the horizontal air flow louvers.
Procedure to enable the automatic restart feature after a power interruption.
Steps to disable the automatic restart feature.
Explanation of protection features and characteristics during heating operation.
Information on heating capacity and precautions regarding snow accumulation.
Response to power failure and recommended operating temperature ranges.
Critical warnings for immediate action when specific issues occur.
Steps to check for common inoperative or performance issues before service.
Explanation of common occurrences that are not considered unit failures.
Notes on heating defrosting, air flow changes, mist generation, and louver behavior.
Detailed technical specifications for the 07 and 10 series models.
Detailed technical specifications for the 13 series models.
Recommended ambient temperatures for optimal cooling, heating, and dry operations.
Troubleshooting problems where setting changes on the remote are impossible.
Resolving issues where the remote control display does not turn on.
Addressing problems where the remote control display disappears.
Troubleshooting the absence of receiving tones from the indoor unit.
