8-7
O
PTIONAL
D
EVICES
2. Remove all cables connected to the computer.
3. Turn the computer upside down and remove the battery pack (refer to Chapter
6, Power and Power-Up Modes.)
4. Remove one screw securing the memory module cover.
5. Lift off the cover.
NOTE: Use a point size 0 Flippest screwdriver.
Figure 8-5 Removing the cover
6. Insert the memory module into the connector on the computer. Press the
module carefully and firmly to ensure a solid connection.
7. Push the module down so that it lies flat and is secured by two latches.
CAUTION: Do not touch the connectors on the memory module or on the
computer. Debris on the connectors may cause memory access problems.
Figure 8-6 Inserting the memory module
Memory expansion
To Next Page
Loading...
