3 Diagnostic Programs 3.2 Quick Start
In this screen, there are two lines which attribute could be edited and updated. The 1
st
line (the font in yellow with blue background) shows the attribute’s value that is read
from the current system and the 2
nd
line (the font in red with turquoise background)
shows the same value as that in the 1
st
line before user’s editing. User can modify the
attribute’s value in the 2
nd
line and press Enter to confirm the current edition and
continue editing the next attribute.
During the editing, user could press F2 to confirm the DMI attribute update or press F4
to ignore the modification. Press ESC to exit the program of DMI Write.
The confirmation screen is as below:
10
Satellite/Satellite Pro/C650/C655 Maintenance Manual
To Next Page
Loading...
