User’s Manual 7-4
HW Setup and Passwords
CPU
Dynamic CPU Frequency Mode
This option allows you to choose from the following settings:
Boot Priority
Boot Priority Options
This option sets the priority for booting the computer.
The Boot Priority Options setting will be like the following
To change the boot drive, follow the steps below.
1. Hold down F12 and boot the computer.
2. Use the up/down cursor keys to select boot device you want and
press ENTER.
Dynamically
Switchable
CPU power consumption and clock speed
automatic switching function is enabled. When
the computer is in use, CPU operation is
automatically switched when necessary.
(Default)
Always Low CPU power consumption and clock speed
automatic switching function is disabled. The
CPU always runs at low power consumption and
low speed.
ExpressCard HDD boot is not supported.
■ If a supervisor password is set, the menu above does not appear when
you use the user password to start the computer.
■ The selection method above does not change the boot priority settings
in HW Setup.
■ If you press a key other than one of those above or if the selected
device is not installed, the system will boot according to the current
setting in HW Setup.
To Next Page
Loading...
