User’s Manual 4-8
Operating Basics
Loading discs
To load a disc, follow the steps as detailed below:
1. When the computer’s power is on, press the eject button to open
the disc tray slightly.
2. Grasp the disc tray gently and pull until it is fully opened.
Pressing the eject button and pulling the disc tray open
3. Lay the disc, label side up, in the disc tray.
Inserting a disc
1. Disc tray 2. Eject button
1. Laser lens
1
2
1
When the disc tray is fully opened, the edge of the computer will extend
slightly over the disc tray. Therefore, you will need to turn the disc at an
angle when you place it in the disc tray. After seating the disc, however,
make sure it lies flat.
Downloaded from LpManual.com Manuals
To Next Page
Loading...
