151
Utilities
Setting passwords
6 Click OK.
The supervisor password utility dialog box appears.
7 Select Able to run HWSetup or Unable to run HWSetup
and then Click OK.
8 Restart the system to complete the process.
Deleting a supervisor password
To delete a supervisor password:
1 Click Start, All Programs, TOSHIBA, Utilities, and then
TOSHIBA Assist.
The TOSHIBA Assist window appears.
2 On the left side, click the Secure tab.
3 Click the Supervisor Password icon.
The Supervisor Password tab of the TOSHIBA Password
Utility window appears.
4 Click Not Registered.
A pop-up screen appears asking for a password.
5 Enter the password, then click OK.
6 Click OK to exit.
7 Restart the system to complete the process.
Using a user password
A user password provides power-on password protection.
Setting a user password
If you choose to set a supervisor or user password, TOSHIBA
strongly recommends that you save your password in a location
where you can later access it should you not remember it.
TOSHIBA is not responsible for any losses that may occur to you, your
organization or others as a result of the inability to access your
computer.
To Next Page
Loading...
