User’s Manual 4-7
Operating Basics
Using optical disc drives
The full-size drive provides high-performance execution of CD/DVD/BD-
based programs. You can run either 12 cm (4.72") or 8 cm (3.15")
CD/DVD/BDs without an adaptor. A Serial ATA interface controller is used
for CD/DVD/BD operation. When the computer is accessing a CD/DVD/BD,
an indicator on the drive glows.
For precautions on writing to CD/DVD/BDs, refer to the Important message
section.
Loading discs
To load a disc, follow the steps as detailed below:
1. When the computer’s power is on, press the eject button to open
the disc tray slightly.
2. Grasp the disc tray gently and pull until it is fully opened.
Pressing the eject button and pulling the disc tray open
3. Lay the disc, label side up, in the disc tray.
Use the DVD playback application to view DVD-Video discs.
1. Disc tray 2. Eject button
1
2
To Next Page
Loading...
