149
If Something Goes Wrong
DVD Blu-ray Disc™ operating problems
helpful if you should confer with a support technician at a later
time.
To enable or disable wireless communication, use the F12 key. For
more information see “TOSHIBA Function Keys” on page 159.
❖ Use IPCONFIG to verify that the computer has a useful IP
address
- one other than the private address of
169.254.xxx.xxx assigned by Windows
®
.
1 From the Start screen, type
Cmd.
2 Click Command Prompt.
3 Enter
IPCONFIG/ALL, and then press ENTER.
The IP address for each active network adapter will be
displayed.
❖ Connect your computer directly to your router or broadband
modem, by plugging a standard CAT5 Ethernet patch cable
(sold separately) into your computer's RJ45 Ethernet port. If
your connection problem disappears, the problem lies in the
Wi-Fi
®
part of your network.
❖ If you have enabled any security provisions (closed system,
MAC address filtering, Wired Equivalent Privacy [WEP], etc.),
check the access point vendor's Web site for recent firmware
upgrades. Problems with WEP keys, in particular, are
frequently addressed in new firmware releases.
DVD Blu-ray Disc™ operating problems
(Available on certain models.)
If you experience a problem playing DVDs or Blu-ray™ Discs, you
may be able to fix the problem yourself.
For general problems playing a DVD or Blu-ray Disc™ title, try the
following steps:
1 Verify that the disc is in a format that the drive supports.
2 Ensure that the disc is properly inserted in the drive tray.
3 Use the DVD or Blu-ray Disc™ player software that came with
your computer to view DVD or Blu-ray Disc™ movies.
4 Clean the disc and try again.
A dirty drive can also cause audio problems. If you have tried
several discs and all fail, consider sending your drive to an
authorized service provider to get it cleaned.
NOTE
To Next Page
Loading...