Screws (1)
(SD-220)
Screws (1)
Rear panel (2)
1-1-4. Tray
1. Pull out the tray (1) towards you until it stops.
2. Lift up claw A with a minus screwdriver, and pull out
the tray (1) towards you, then remove the tray (1).
Fig. 2-1-5
1-1-5. Rear Panel
1. Remove eight screws (1), then remove the rear panel
(2). (In case of SD-120, remove seven screws (1), then
remove the rear panel (2).)
Fig. 2-1-6
Tray (3)
Tray
panel (4)
Tray (3)
Claws
Tray
panel (4)
A
B
<Tray Panel Removal>
1. Eject the tray (1). (Refer to item 1-1-2.)
2. Twist the tray panel (2) a little in the arrow A direction
with the tray (1) hold by hand to release two claws and
lift up the tray panel (2) in the arrow B direction, then
the tray panel (2) is removed.
3. When mounting the tray panel (2), insert the tray panel
(2) along the grooves of the both sides of the tray (1)
until clicking.
Front
panel (4)
Claws
Claw
Claw
Flexible
cable (1)
Screw (2)
GND
lead (3)
Fig. 2-1-3
1-1-3. Front Panel
1. Remove one flexible cable (1).
2. Remove one screw (2), then remove the GND lead (3).
3. Release four claws, then remove the front panel (4).
Fig. 2-1-4
Mechanism
chassis assembly
Tray (1)
Pull out the tray (1)
toward you.
Tray (1)
Minus screwdriver
Claw A
Minus
screwdriver
To Next Page
Loading...
