Toshiba SD-220EB - Page 88

2-2-2. Power PC board
1. Peel off two tapes (1) and remove the connector (2).
2. Remove four screws (3), then remove the power
supply PC board (4).
Fig. 2-1-22
Connector (2)
Connector (2)
Tapes (1)
Power supply
PC board (4)
Screws (3)
Twist more than 9 times.
2-2-3. Output PC Board
1. Eject the tray slightly.
2. Peel off a tape (1).
3. Remove the connector (2) and the flexible cable (3).
4. Remove two screws (4), then remove the output-RGB
PC board (5).
Note:
• Wind the wire around the connector (6) several times
when mounting the connector (2).
Fig. 2-1-23
Tape (1)
Output RGB PC board (5)
Screws (4)
Connector (2)
Connector (6)
Connector (2)
Connector (6)
Flexible
cable (3)
Tray
Wind the wire
several times.
Eject the tray slightly.