65
Connections
Connecting to an audio system equipped
with analog audio inputs
Make the
following setting.
Setting Select: Page
“Digital Out” “Analog 2ch”
58
Note
• DO NOT connect the BITSTREAM/PCM jack of the player to
the AC-3 RF input of a Dolby Digital Receiver. This input on
your A/V Receiver is reserved for Laserdisc use only and is
incompatible with the BITSTREAM/PCM jack of the player.
CAUTION
• When you are connecting (via the BITSTREAM/PCM
jack) an AV decoder that does not have Dolby Digital,
Digital Theater Systems (DTS) or MPEG2 decoding
function, be sure to set “Digital Out” to “PCM” from the
on-screen displays
58
. Otherwise, high volume sound
may damage your hearing as well as the speakers.
• When playing DTS-encoded discs (audio CDs),
excessive noise may be output from the analog audio
output jacks. To avoid possible damage to the audio
system, you should take proper precautions when the
analog audio output jacks of the player are connected to
an amplifi cation system. To enjoy DTS Digital Surround
®
playback, an external 5.1 channel DTS Digital Surround
®
decoder system must be connected to the BITSTREAM/
PCM jack of the player.
To analog audio inputs
To AV OUT
Signal flow
Audio system
Audio/video cable
(supplied)
AUDIO IN
R
L
Red (Right)
White (Left)
Yellow (Video)
No need to connect.
SD-P1900SN-E_P53-84.indd 65SD-P1900SN-E_P53-84.indd 65 07.3.10 5:45:18 PM07.3.10 5:45:18 PM
To Next Page
Loading...
