Toshiba America Information Systems Inc. ("TAIS") shall not be liable for damages of any kind for use of this information, which is subject to
change without notice. Copyright 1994 TAIS. 5100.DOC Rev. 1 06/02/94 MQC/nmm.
Page 5
T5100
(continued)
3.5" 100MB Hard Disk Drive
Conner Peripherals HDD: CP-30104
Interface: IDE
Average access time: 25ms
Recording method: 2 - 7 RLL
TEST3 setup type: 9
Soft Switches
1) Change CPU speed
Fn + PgUp 16MHz CPU speed
Fn + PgDn 8MHz CPU speed
2) Character font
Fn + Right arrow Toggles display font
3) Display select
Fn + End External display
Fn + Home Plasma display
4) Extending the display area
Fn + Down arrow Toggles between 350 and 400 rows in EGA mode
5) Keypad overlay
Fn + NumLock Toggles keyboard overlay
6) Fn key
Fn + F1 F11
Fn + F2 F12
Fn + Ctrl Simulate IBM enhanced keyboard Right Ctrl
Fn + Alt Simulate IBM enhanced keyboard Right Alt
Fn + Enter Simulate IBM enhanced keyboard numeric keypad Enter
Fn + power on Force T5100 to CMOS setup screen
Hardware Switches and Controls
1) Power on/off
Located on back of computer
2) A/B/PRT switch
Located on left side of computer
With switch set to "A", external FDD port is accessed as drive A; internal 3.5" FDD as drive B.
With switch set to "B", external FDD port is accessed as drive B; internal 3.5" FDD as drive A.
Switch is set to "PRT" for parallel printer output.
Computer must be re-booted for switch change to take effect.
3) Plasma display brightness and contrast dials
Located on front of display
4) 6 DIP switch bank
Located on back of computer
Factory default settings all off (off=down)
SW1 OFF Expanded or Extended ON Expanded Memory Only
Memory enabled Disables Extended Memory
SW2 OFF 640K Base Memory ON 512K Base Memory
SW3 OFF Enable Internal video controller ON Disable Internal video controller
SW4 OFF PRT Output Only ON PRT Bidirectional
SW5 OFF Normally off ON For use with ISC UNIX
SW6 OFF Serial Port COM 1 ON Serial Port COM 2
T5100
(continued)
To Next Page
Loading...
