2. Setting-Up OPC Server
13
<3> Select <Repair> and click <Next>.
<4>An inquiry doing DCOM setting is displayed.
When set it automatically, Click < Yes >.
When set a manual operation later, Click < No >.
A displayed message changes by the insta
type that selected in <6>.
About contents of setting, please refer to "3.1.
DCOM Setting ".
* : DCOM setting function added in V01.40.
<5> DCOM setting is completed.
Click < OK >.
<6>When installation type that selected "Both" or
"Server" in <6>, an inquiry starting Log Save
Tool processing automatically is displayed.
* : Log Save Tool function added in V01.40
<7>Reinstallation is completed. Click <Finish>.
Figure 2.3 Repair of OPC Server
To Next Page
Loading...
