B-12 User’s Manual
Display Controller and Modes
Figure B-4 WinDVD 5.0 Sub-panel
■ The following [Set up] screen is displayed, then remove the check of
[Use Hardware Decode Acceleration]
(The check of [Use Hardware Color Acceleration]is removed
automatically).
Figure B-5 Setup
■ Click [OK] button(The [Set up] tab closes automatically).
4. The DVD video overlay is not displayed when the display mode of CRT
display is set to high resolution and hifh refresh rate mode at LCD/CRT
simultinous or multi-monitor.
Please decrease the resolution and refresh rate of CRT display.
5. When the display mode is TV or simultaneous LCD (internal liquid
crystal display)/TV and the system goes into Standby or Hibernation
mode, you can switch to the LCD (internal liquid crystal display) display
mode by pressing [Fn] + [F5]. Under this environment, however, you
may not return to the TV or simultaneous LCD (internal liquid crystal
display)/TV display mode.
In these cases, perform the following steps:
Press [Ctrl] + [Alt] + [F12] to select [Intel(R) 82852/82855 GM/GME
Graphics Controller Prope...]. Then click the icon indicating a display
device (display mode) you want to use in the left pane of the [Devices]
tab.
To Next Page
Loading...
