Replacing the cap
The AccuPoint cap is an expendable item that should be replaced after
prolonged use.
1. To remove the AccuPoint cap, gently dig the cap out (with finger).
Figure 4-5 Removing the AccuPoint cap
1. AccuPoint cap
Product appearance depends on the model you purchased.
2. Position a new cap on the peg and press it into place.
The peg is square, so be careful to align the cap’s square hole with
the peg.
You can buy replacement AccuPoint caps from your TOSHIBA
authorized dealer.
Using the Fingerprint Sensor
Some models are equipped with the fingerprint sensor for the purpose of
enrolling and recognizing fingerprints. Follow the on-screen instructions to
finish the setup.
By enrolling the ID and password onto the fingerprint authentication
feature, it is no longer necessary to input the password from the keyboard.
Fingerprint feature enables you to:
Unlock the password-protected screen-saver.
Authentication of the User Password (and, if applicable, the HDD/SSD
Password) when booting up the computer (Pre-Boot authentication).
Single Sign-On feature
Fingerprint cannot be used in models that do not have a fingerprint
function.
User's Manual 4-13
To Next Page
Loading...
