34
CONTROLS AND FEATURES
English
Setting up the Network
You can select the Network Type.
a Press MENU / C c to highlight PREFERENCES icon.
b Press B or b to select Network Setup and press OK.
c Press B or b to select Network Type and press C or
c to select Wired or Wireless.
NOTE: If the Dual Band WLAN Adaptor is not
connected, Wireless cannot be selected.
d If you selected Wired, see “Advanced Network Setup”
on page 36.
NOTE:
• This feature is grayed out when the Dual Band WLAN
Adaptor is not connected or Network Type is set to Wired.
• When you insert or remove the wireless LAN adaptor, you
must turn off your TV and unplug the power cord, and then
plug and turn on again.
• Continued connection of AP (Access Point) is not
guaranteed. The connection may be disconnected while
watching TV.
• Do not remove the Dual Band WLAN Adaptor when
Network Type is set to Wireless or wireless
communication is active.
There are 2 methods for Wireless Setup:
Assisted setup by using the Wi-Fi Routers notification
information.
Network name, Authentication and Encryption are decided
based on information sent from the Wi-Fi router. Security key
to be set manually.
Manual setup
Network name, Authentication, Encryption and Security Key
all to be inputted manually.
Assisted Setup
a In the PREFERENCES menu, press B or b to select
Network Setup and press OK.
b Press B or b to select Wireless Setup and press OK.
c Press B or b to select Assisted Setup and press OK.
d Press B or b to select the desired AP and press OK.
NOTE: Check the MAC address on the label of the AP
or in the manual, and select your AP.
e Highlight Security Key and press OK. The Software
Keyboard window will appear.
f Input the Security Key by using the Software
Keyboard (see page 38). To save your setting, press
the BLUE button.
NOTE:
• The Security Key must adhere to these conditions:
- TKIP/AES: 8-63 ASCII or 64 Hex characters
- WEP: 5 or 13 ASCII or 10 or 26 Hex characters
• There is only one key ID to set for WEP encryption.
g Highlight Done and press OK.
NOTE: If Network Name is not displayed, see step 4
and 5 in Manual Setup below to set Network Name
before pressing Done.
NOTE: Settings are not saved if BACK is pressed before Done
is selected.
Manual Setup
a In the PREFERENCES menu, press B or b to select
Network Setup and press OK.
b Press B or b to select Wireless Setup and press OK.
c Press B or b to select Manual Setup and press OK.
d Press B or b to select Network Name and press OK.
The Software Keyboard window will appear.
e Input the Network Name by using the Software
Keyboard (see page 38). To save your setting, press
the BLUE button.
Wireless Setup
To Next Page
Loading...
