21
Technical Information
Service Manual
6
Pressthisbuttontoset up &downswing angle,which circularly changesasbelow
:
This remote controller is universal . If any command
the unit will carry out the com-
indicates the guide louver swings as:
Press this button to turn on I FEEL function. The unit automatically adjust temperature according to the sensed temperature.
Press this button again to cancel I FEEL function.
I FEEL:
SWING:
7
MODE
:
*
*Note:Only for models with heatingf unction.
After energization, AUTO mode is defaulted. In AUTO mode, the set temperature will not
be displayed on the LED of the
indoor, and the unit will automatically select the suitable operation mode in accordance with the room temperature to make
indoor room comfortable.
This button is used for setting Fan Speed in the sequence that goes from AUTO,
to
then back to Auto.
,
,,
,
:
4
5
Auto
Medium speedLow-Medium speedLow speed
High speed
Medium-High speed
Each time you press this button,a mode is selected in a sequence that goes from AUTO,COOL,DRY, FAN,and HEAT
*
,
as the following:
AUTO
COOL DRY FAN HEAT
, or is sent out,
mand as
FAN
/
8
P
ress this button to achieve the on and off of healthy and scavenging functionsin operation status.Press this button for the
first time to start scavenging function;LCD displays“ ”.Press the button for the
second time to start healthy and scaveng-
ing functions
simultaneously;LCD displays“ ” and “ ” .Press this button for the third time to quit healthy and scavenging
functions simultane ously .Press the button for the fourth time to start healthyfunction;LCD display“ ”.Press this button
aga in to repeat the operation above.
SLEEP :
9
Press this button,can select Sleep1( ),Sleep2( ),Sleep3( )and cancel the Sleep,circulate between these,after
electrified,Sleep Cancel is defaulted.
Sleep 1 is Sleep mode 1, in Cool,Drying modes:sleep status after run for one hour,the main unit setting temperature
will increase 1
,setting temperature in creased 2 ,the unit will run at this setting temperature;In Heat mode: sleep status afte
run for one hour, the setting temperature will decrease 1 ,2 hours,setting temperature will decrease 2 ,then the unit will
run at this setting temperature.
OFF
To Next Page
Loading...
Need help?
General