Totally Wicked Skope S User Manual

QUICK START GUIDE
For those familiar with e-cigarettes, the steps below can
be followed to allow the device to be used in the shortest
possible time:
• Prime the atomizer head
• Fill the tank
• Switch the Skope S on
• Press the power button and inhale
• Charge the battery (it may not have been shipped with
a full charge)
USING YOUR SKOPE S
Priming the Atomizer Head
Note: It is important to “prime” a new atomizer head before rst use. Failure to do so
can cause the atomizer coil to overheat, leading to an unpleasant taste and sometimes
irreversible damage to the atomizer head requiring early replacement.
To prime the atomizer head, remove the mouthpiece from the tank by unscrewing, then
remove the glass section of the tank by pulling upwards. Unscrew the atomizer head and
prime by dripping a few drops of e-liquid onto the cotton visible through the sides of the
atomizer. After priming, screw the atomizer head back into place, replace the glass section
and screw the mouthpiece back on.
Filling the Tank
Remove the mouthpiece from the tank by unscrewing.
Fill the tank with e-liquid, being careful not to overll and
avoid lling down the central airow hole. Once lled,
ret the mouthpiece.
Powering On and O:
To switch on, quickly press the power button ve times;
the indicator light will ash three times. Quickly press the power button ve times to turn
the battery o; the indicator light will ash three times.
Vaping:
Press and hold the power button as you inhale the vapour.
Power
Button
Charging Port
Skope S
Tank
Skope S
Battery
Note: Leave a new
atomizer head to sit with
the tank full of e-liquid
for ve minutes before
vaping. This ensures the
atomizer head is fully
saturated with e-liquid
before use.
USER MANUAL
CONGRATULATIONS ON PURCHASING YOUR
TOTALLY WICKED SKOPE S ELECTRONIC CIGARETTE KIT

Totally Wicked Skope S Specifications

General

Brand	Totally Wicked
Model	Skope S
Category	Electronic Cigarettes
Language	English

Summary

Using Your Skope S

Priming the Atomizer Head

Prime a new atomizer head before first use by dripping e-liquid onto visible cotton.

Filling the Tank

Fill the tank with e-liquid, avoiding the central airflow hole and overfilling.

Powering On and Off

Quickly press the power button five times to switch the device on or off.

Vaping

Press and hold the power button while inhaling vapour.

E-liquid Level Management

E-liquid Level

Ensure fluid level stays above atomizer feed holes to prevent premature burning.

Charging the Battery

Charge the Skope S via USB; indicator light is red while charging, switches off when full.

Replacing the Atomizer Head

Follow priming steps to remove, replace, and reassemble the atomizer head.

Device Protections

Short Circuit Protection

Flashes three times and switches off; replace atomizer and charge battery.

No Atomizer Detected

Flashes continuously; ensure atomizer head is fitted properly.

Atomizer Head Protection

Flashes eight times and switches off if held over 15 seconds; release button and recharge.

Product Information and Precautions

Specifications

Details dimensions, weight, battery, modes, connections, tank capacity, and filling method.

Additional Product Information

No reported medical side effects; contact manufacturer for any experienced side effects.

Product Storage and Battery Precautions

Store away from children; use provided cable; dispose of batteries properly; avoid extreme temperatures.

Warranty

28-day parts warranty (except atomizer heads), 12-month warranty for USB cable.