TotalPond 52766 - Page 8

VISIT WWW.TOTALPOND.COM FOR INFORMATION AND TIPS.
EN
8
Step 5. Assemble the
nozzle head back to your
nozzle kit.
Step 6. Light ring can
use in or out of the water,
adjust the light ring up
and down to the desire
location.
Step 7. Connect the
light ring to the sensor by
pushing the plug into the
sensor socket until it is
firmly seated. Hand tighten
the nut from the plug to the
socket.
Step 8. Connect the
sensor to the transformer
by pushing the plug into the
transformer socket until it is
firmly seated. Hand tighten
the nut from the plug to the
socket.
Step 9. Make sure that the
transformer and sensor
are NOT submerged. Make
sure that the light sensor
faces up.
NOTE: At night, the lights
will automatically turn on.
At sunrise, they will automatically
turn off.
Step 10. Plug the transformer
into a properly grounded electrical
outlet
5 6
7
8
9
10