7
totemacoustic.com
CONNECTIONS
All connections should be made with the equipment turned off.
Totem delivers all speakers with jumpers installed. For a standard single wire connection simply leave
the jumpers in place. Be certain to connect the positive red (+) terminal of the speaker to the positive
red (+) output terminal on the amplifier. Be certain to connect the negative black (-) terminal of the
speaker to the negative black (-) output terminal on the amplifier. The speakers will sound out of phase
(bass loss and image distortion) if there is an error in your connection. Totem speakers can be bi-amped
and bi-wired, please consult your amplifier manual for detailed instructions or contact your Totem
Authorized Dealer.
TROUBLESHOOTING GUIDE
No sound: Verify that your pre-amp and/or amplifier, and receiver are plugged into the AC PLUG and are
turned on. Verify that the wall AC outlet is functional and that your system is not on mute.
Sound from one speaker only: Verify the balance control on your system. Swap speaker sides to verify if
speaker is functional. Verify power cords on all sources. (Amplifier, preamp, receiver, CD, DVR)
Lack of bass or image: Verify the polarity of speaker connections.
To Next Page
Loading...