5
ENGLISH
7. Install the faucets and drain (not
supplied) per the manufacturer’s
installation instructions.
8. Return the lavatory into position with
the marks on the wall.
9. Install the lavatory mounting
hardware. Place a metal washer onto
a screw.
10. Insert the screw through a mounting
hole in the lavatory.
NOTE: DO NOT SECURE THE SCREW AT
THIS TIME.
12. Place the remaining metal washer
onto the screw. Insert the screw
through the remaining mounting hole
in the lavatory.
13. Level the lavatory with the mark along
the top and sides of the lavatory.
14. Secure the lavatory to the wall.
DO NOT OVERTIGHTEN.
Overtightening may damage the
products and cause personal injury
and/or property damage.
WARNING
1. Connect the water supply to the faucet according to the faucet
instructions.
2. Connect and tighten the trap to the drain.
3. Turn on the water supplies to the faucet.
4. Purge the air from the hot and cold water by running the water for a few
seconds.
5. Fill the lavatory with water.
6. Check the leaks at the water supply and drain connections.
INSTALLATION PROCEDURE
Lavatory Installation (continued)
Faucet and Drain Connections (Not Supplied)
To Next Page
Loading...
