18
PART 4. TROUBLESHOOTING
Brewer does not have power.
• Plug the brewer into an independent outlet.
• Check to be sure that it is plugged in securely.
• Plug into a different outlet.
• Reset your home’s circuit breaker, if necessary.
• Make sure that the Power Button has been turned ON and the Power Light is illuminating.
Brewer will not brew.
• If the upper left blue Low Water Light is blinking, then add water to the Water Tank. Make sure the Water Tank is seated and secured in properly on its base.
• If the blue Low Water light continues to blink after refilling the Water Tank, double check to make sure the Water Tank is secured properly behind the brewer.
• Double check the top needle underneath the cover to see if it is clear of coffee grind. If the top needle is clogged use a paper clip or tooth brush to unclog
the top needle.
• Check to make sure Pod is not damaged.
Brewing a partial cup.
• Double check the top needle to see if it is clogged. If so, unclog the top needle using a paper clip or a tooth brush.
• Double check the Red Cup Holder to see if the two bottom needles are clogged. If they are clogged, then use a paper clip or a tooth brush to clean the
two bottom needles.
• De-scale the brewer using the steps in PART 3.
• If you have repeated the de-scale procedure on your brewer two times and it is still only brewing a partial cup, contact Customer Service.
Brewer shuts off automatically.
• The brewer is designed to automatically turn OFF after 30 minutes of non-use to conserve power.
• If the blue Low Water Light is blinking, then add water to the Water Tank. Make sure the Water Tank is secured properly on its base.
• Double check the top needle underneath the cover to see if it is clear of coffee grind. If the top needle is clogged use a paper clip or tooth brush to unclog
the top needle.
To Next Page
Loading...