COLOR button: Makes the color flame effect changing.
NOTE: color effect stays on until power button is turned off.
Color flame effect must be on for heater to turn on.
FLAME button: Makes flame effect dimmer and brighter.
NOTE: Flame effect stays on until power button is turned off.
Flame effect must be on for heater to turn on.
Co Controls the Heater.
Press button to initiate the heater.
(H0) no heater or blower.
(H1), heater blows warm air (750W)
(H2), heater blows hot air (1500W)
(H (H0) no heater,blower will be off after10s.
NOTE: Heater functions cycle from H0-H1-H2-H0, Press
and hold the heater button for 5s, the heater and
temperature setting will be locked onto the selected
setting. Hold the button for 5s again, the heater will be
unlocked.
When the heater is first turned on, a slight odor may be present. This is normal and
should not occur again unless the heater is not used for a long period of time.
To improve operation, aim the remote control at the front of the fireplace. DO NOT
press the buttons too quickly. Give the unit time to respond to each command.
To Next Page
Loading...
