ToughTested TT-SP45 - Speaker Status and Charging; Low Power and LED Indicators; Speaker Charging Process; LED Status Light Meanings

04 05
FUNCTION
LOW POWER INDICATION
See how much battery power the Rugged Speaker has left, with four LED lights. If all 4 LEDs illuminate, the
device is fully charged. If only 3 illuminate the device is 75% charged, 2 means only 50% charged, and 1
means 25% or less. When the speaker reaches 10% battery life, a voice prompt will inform you that it is time
to charge the speaker.
CHARGING THE SPEAKER
1. Connect the included USB cable to your computer or USB power adapter.
2. 4 white LEDs illuminate. 1 light indicates 25% battery life. 2 lights indicate 50% battery life, 3 lights 75%
battery life, 4 lights indicate 100% battery life.
3. A blinking white light indicates the battery is charging.
4. illuminated white lights indicate that charging in complete.
LED STATUS
1. Bluetooth Mode: Blue light flashes when ready to pair. Blue light stays lit once connected.
2. AUX mode: Green light stays lit
3. Charging Status: 4 white LEDs illuminate. 1 light indicates 25% battery life. 2 lights indicate 50% battery
life, 3 lights 75% battery life, 4 lights indicate 100% battery life. A blinking white light indicates the battery is
charging. 4 illuminated white lights indicate charging is complete.
FUNCTION
FUNCTION OPERATION
Answering calls
When receiving an incoming call, short press to answer the call and short press again to
end the call.
End or reject a call Short press key to end the call or long press to reject the call
Power ON/OFF Long press to ON/OFF
Play/Pause Short press control music playback
Volume – or + Short press +/- to raise/lower volume
Next/previous Long press + to skip to the next track. Long press - to skip to the previous track
Un-pairing the
Bluetooth connection
Long press to disconnect the
current Bluetooth connection and search for a new device
Flashlight
Short press to change 4 modes of the flashlight (normal mode, quick flash mode,
SOS slow flash mode, flashlight OFF)
Note:
1. If the device is in Bluetooth mode and a wire is inserted into the 3.5mm audio jack, the speaker will
automatically switch to AUX mode.
2. Turn off the speaker when it is not in use to conserve power.battery life.