9-2021
Burners and pilots
• For pilot burners
o Check that pilot is working with proper flame height.
o Clean orifice, clean air holes, adjust pilot valve, and/or replace pilot as needed.
o Ensure pilot burner is mounted properly.
• For jet burners
o Verify that all ports/jets light. It’s normal for some ports/jets to not light until a wok is placed on the
chamber or blown on. Flame should be mainly blue, slight yellow/orange tipping is OK.
o For jet tips that do not light, ensure orifice and air holes are not clogged. Clean as needed with
thumb drill and wire brush cleaner.
o Check that all jet tips are attached and intact- replace tips or burners as needed.
o Replace tips that have been over drilled while cleaning.
• For ring burners
o Remove and disassemble air mixers. Remove any blockages and clean the orifices.
o Remove any blockages from the ports in the cast iron burner.
o Reassemble and set air mixer disc for proper combustion.
Faucets
• Chinese Swing Faucets - Check for leaks and tighten or repair as needed.
o Tighten nuts and unions.
o Replace missing aerators.
o Replace bent spouts.
o If faucet is stuck, not turning on or leaking, replace the entire faucet or repair using parts from our
rebuild kit.
• Manual Faucets - Check for leaks and tighten or repair as needed.
o Tighten handle screw, replace if missing.
o Tighten spout nut.
o Replace cartridge if faucet is constantly on or not turning on at all.
o Replace nozzle if bent.
Water wash & sink
o EcoDeck units: Check for proper operation of the plunger valve. It should turn off automatically after about
a minute. If stuck on, clean filter within valve or replace the cartridge.
o Check that the water is distributed across the deck and reaches both ends of the range. Clean spray bar,
level/pitch the unit, or adjust water pressure regulator or incoming water supply as necessary.
o Check for proper flow through 2” drain. Remove any clogs/blockages.
o Verify that the integrated scrap bin and mesh strainer is in place. Replace any broken or missing parts.
o Verify all drip pans are in place. Replace any broken or missing pans.
To Previous Page
Loading...