To Next PageTo Next PageWhat to do if my Toyostove Laser 56 Type I fuel pump sound does not decrease and the heater shuts off?
If the sound from your Toyostove Heating System fuel pump doesn't decrease and the heater shuts off, try the following: 1. Push the red reset button on the fuel sump (do not hold it down). 2. Make sure all valves are open and the filter is clear. 3. Confirm that the external fuel tank has fuel and that its filters are clean.
Why is my Toyostove Heating System fuel pump making a chugging sound when started?
The audible chugging sound from your Toyostove Heating System fuel pump, especially when started for the first time or after running out of fuel, is likely due to air in the pump. This noise should stop within one minute.
Provides crucial advice for safe operation of the heating unit.
Steps required before starting the heater for the first time.
How to operate the heater manually for heating.
How to program and use the heater's automatic modes.
Procedure for safely shutting down the heater after use.
Method for manually setting the heater's combustion mode.
Information on the automatic igniter cleaning cycle.
Procedure for manually initiating the igniter cleaning cycle.
Lists the tools required for installing the heater.
Identifies the parts included with the heater for standard installation.
Details available optional parts for non-standard installations.
Provides essential safety guidelines for the installation process.
Step-by-step instructions for installing the heater and flue system.
Guidance for setting up a permanent electrical wiring connection.
Instructions for installing an external fuel tank system.
General| Fuel Type | Kerosene |
|---|---|
| Ignition | Automatic |
| Ignition Type | Electric |
| Thermostat | Yes |
| Ventilation | Direct Vent |
| Safety Features | Overheat protection |
