Toyota 2000 MR2 Spyder - Replacing Light Bulbs

MR2 U
200
2000 MR2 (OM17475U)
NOTICE
Do not use engine antifreeze or any
other substitute because it may dam-
age your vehicle’s paint.
Replacing light bulbs—
The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
CAUTION
Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter if scratched
or dropped. Hold a bulb only by its
plastic or metal case. Do not touch
the glass part of a bulb with bare
hands.
NOTICE
Only use a bulb of the listed type.
Light bulbs
Bulb
No.
W Typ e
Headlights — 60/55 A
Parking lights — 5 B
Front turn signal
lights
— 21 B
Front side marker
lights
— 3.8 B
Rear turn signal
lights
— 21 C
Stop/tail lights — 21/5 B
Stop lights — 21 B
Back- up lights — 21 B
License plate lights — 5 B
Interior light — 8 D
High mounted stop
light
— 5 B
A: HB2 halogen bulbs
B: Wedge base bulbs
C: Single end bulbs
D: Double end bulbs