A62178
Push
A62180
Disconnect
Hook
Pin Turn
A62181
Plunger
Turn
Push
A11858
–ENGINE MECHANICAL CAMSHAFT
14–105
2004 COROLLA (RM1037U)
(2) Apply engine oil to the chain tensioner and install it
with the 2 nuts.
Torque: 9.0 N⋅ m (92 kgf⋅cm, 80 in⋅ lbf)
NOTICE:
When installing the tensioner, set the hook again if the
hook release the plunger.
(3) Turn the crankshaft counter clockwise, and discon-
nect the plunger knock pin from the hook.
(4) Turn the crankshaft clockwise, and check that the
slipper is pushed by the plunger.
HINT:
If the plunger does not spring out, press the slipper into the
chain tensioner with a screwdriver so that the hook is released
from the knock pin and the plunger springs out.
17. ADJUST VALVE CLEARANCE (See page
14–5)
18. INSTALL V–RIBBED BELT TENSIONER ASSY
(a) Install the V–ribbed belt tensioner with the nut and bolt.
Torque:
Nut 29 N⋅m (296 kgf⋅cm, 21 ft⋅ lbf)
Bolt 69 N⋅m (704 kgf⋅cm, 51 ft⋅ lbf)
To Next Page
Loading...
