Toyota 2001-2004 Corolla - INSTALL CAMSHAFT

B06777
A62150
A62825
6248
5137
11
10
9
A64026
14–120
–ENGINE MECHANICAL CYLINDER HEAD GASKET
2004 COROLLA (RM1037U)
51. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE
ASSY
(a) Apply a light coat of engine oil on a new O–ring, and install
it to the camshaft timing oil control valve.
(b) Install the camshaft timing oil control valve with the bolt.
Torque: 9.0 N⋅ m (92 kgf⋅cm, 80 in.⋅ lbf)
52. INSTALL CAMSHAFT
(a) Apply a light coat of engine oil on the camshaft journals.
(b) Place the 2 camshafts on the cylinder head with the No.
1 cam lobes facing as shown the illustration.
(c) Examine the front marks and numbers and tighten the
bolts in the order shown in the illustration.
Torque:
Bearing cap No. 1 23 N⋅m (235 kgf⋅cm, 17 ft⋅ lbf)
Bearing cap No. 3 13 N⋅m (133 kgf⋅cm, 10 ft⋅ lbf)
53. INSTALL WATER BY–PASS PIPE NO.1
(a) Install the water by–pass pipe with the 2 bolts.
Torque: 9.0 N⋅ m (92 kgf⋅cm, 80 in.⋅ lbf)
54. INSTALL OIL LEVEL GAGE GUIDE
(a) Apply a light coat of engine oil on a new O–ring, and install
it to the oil level gage guide.
(b) Install the oil level gage guide with the bolt.
Torque: 13 N⋅ m (133 kgf⋅cm, 10 ft⋅lbf)