Toyota 2001 MR2 Spyder - Positioning the Jack

01MY MR2(U) L/O 0008
169
2001 MR2 (OM17482U)
Tool s:
! Rag or paper towel
! Funnel (only for adding fluid)
Checking power steering fluid
Parts (if level is low):
! Toyota P.S fluid EH or equivalent
Tool s:
! Rag or paper towel
! Funnel (only for adding fluid)
Checking battery condition
Tool s:
! Warm water
! Baking soda
! Grease
! Conventional wrench (for terminal
clamp bolts)
Checking and replacing fuses
Parts (if replacement is necessary):
! Genuine Toyota fuse or equivalent with
same amperage rating as original
Adding washer fluid
Parts:
! Water
! Washer fluid containing antifreeze
(for winter use)
Tool s:
! Funnel
Replacing light bulbs
Parts:
! Bulb with same number and wattage
rating as original (See charts in
“Replacing light bulbs—” on page 188
in Section 7–3.)
Tool s:
! Screwdriver
Positioning the jack
SB71008
Front of vehicle
When jacking up your vehicle with the
jack, position the jack correctly as
shown in the illustration.
Jack position
. . . . . . . . . . . . . . . . .
Front– Front crossmember
Rear– Rear engine mounting bracket
Support position and
Pantograph jack position
. . . . .