Toyota 2002 Sequoia - CHILD RESTRAINT SYSTEM INSTALLATION; Type A-; Type B-

02_SEQUOIA_U (L/O 0108)
102
2002 MY SEQUOIA_U (OM34418U)
Cover
Type B
CHILD RESTRAINT SYSTEM
INSTALLATION
Type A —
1. Turn up the cover for lower anchor-
ages of the right side position.
2. Widen the clearance between the
seat cushion and seatback a little
and confirm the position of the low-
er anchorages below the tag in the
seat cushion.
3. Latch the hooks of lower straps onto
the anchorages and tighten the lower
straps.
Type B —
1. Turn up the cover for lower anchor-
ages of the right side position.
2. Widen the clearance between the
seat cushion and seatback a little
and confirm the position of the low-
er anchorages below the tag in the
seat cushion.
3. Latch the buckles onto the anchor-
ages.
If your child restraint system has a top
strap, it should be anchored. (For the
installation of the top strap, see “—Using
a top strap” on page 97 in this section.)
For the installation details, refer to the
instruction manual equipped with each
product.
CAUTION
! When using the lower anchorages
for the child restraint system, be
sure that there are no irregular ob-
jects around the anchorages or that
the seat belt is not caught.
! Push and pull the child restraint
system in different directions to be
sure it is secure. Follow all the
installation instructions provided by
its manufacturer.
! When using lower anchorages for a
child restraint system on the third
seats, ensure that the seat is
moved to the rear−most position,
with the seatback close to the child
restraint system.
! After securing the child restraint
system, never slide or recline the
seat.