02_SEQUOIA_U (L/O 0108)
188
2002 MY SEQUOIA_U (OM34418U)
6. Test the operation of the HomeLink
"
by
pressing the newly programmed button.
Check to see if the gate/device oper-
ates correctly.
7. Repeat steps 1 through 6 for each re-
maining HomeLink
"
button to program
another device.
Programming other devices
To program other devices such as home
security systems, home door locks or
lighting, contact your authorized Toyota
dealer for assistance.
Reprogramming a button
Individual HomeLink
"
buttons cannot be
erased, however, to reprogram a single
button, follow the procedure “Programming
the HomeLink
"
”.
(b) Operating the HomeLink
"
To operate the HomeLink
"
, press the
appropriate HomeLink
"
button to activate
the programmed device. The HomeLink
"
indicator light should come on. The
HomeLink
"
continues to send the signal
for up to 20 seconds as long as the
button is pressed.
(c) Erasing the entire HomeLink
"
memory (all three programs)
To erase all previously programmed codes
at one time, press and hold down the 2
outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase
the programs stored in the HomeLink
"
memory.
CAUTION
# When programming the HomeLink
"
Universal Transceiver, you may be
operating a garage door or other
device. Make sure people and ob-
jects are out of the way of the ga-
rage door or other device to pre-
vent potential harm or damage.
# Do not use this HomeLink
"
Univer-
sal Transceiver with any garage
door opener that lacks the safety
stop and reverse feature as re-
quired by federal safety standards.
(This includes any garage door
opener model manufactured before
April 1, 1982.) A garage door open-
er, which cannot detect an object,
signaling the door to stop and re-
verse, does not meet current feder-
al safety standards. Using a garage
door opener without these features
increases risk of serious injury or
death.
To Next Page
Loading...
