’03 HIGHLANDER_U (L/O 0208)
289
2003 HIGHLANDER from Aug. ’02 Prod. (OM48441U)
TRANSFER
(four−wheel drive models)
Oil capacity, L (qt., Imp. qt.):
0.9 (1.0, 0.8)
Oil type:
Hypoid gear oil API GL−5
Recommended oil viscosity:
Above −18_C (0_F)
SAE 90
Below −18_C (0_F)
SAE 80W or 80W−90
REAR DIFFERENTIAL
(four−wheel drive models)
Oil capacity, L (qt., Imp. qt.):
0.9 (1.0, 0.8)
“Toyota Genuine Differential Gear Oil” is
filled in your Toyota vehicle. Use Toyota
approved “Toyota Genuine Differential
Gear Oil” or equivalent to satisfy the fol-
lowing specification.
Oil type:
Hypoid gear oil API GL−5
Recommended oil viscosity:
Above −18_C (0_F)
SAE 90
Below −18_C (0_F)
SAE 80W or 80W−90
Please contact your Toyota dealer for fur-
ther details.
BRAKES
Minimum pedal clearance when depressed
with the force of 490 N (50 kgf, 110 lbf)
with the engine running, mm (in.):
106 (4.2)
Pedal free play, mm (in.):
1—6 (0.04—0.24)
Pad wear limit, mm (in.):
1.0 (0.04)
Lining wear limit, mm (in.):
1.0 (0.04)
Parking brake adjustment when depressed
with the force of 294 N (30 kgf, 66 lbf):
5—7 clicks
Fluid type:
SAE J1703 or FMVSS No.116 DOT 3
STEERING
Wheel free play:
Less than 30 mm (1.2 in.)
Power steering fluid type:
Automatic transmission fluid DEXRONrII
or III
Tire size:
P225/70R16 101S
Tire pressure, kPa (kgf/cm
2
or bar, psi):
210 (2.1, 30)
When driving under the above vehicle load
conditions at sustained high speeds above
160 km/h (100 mph), in countries where
such speeds are permitted by−law, inflate
the front and rear tires to 240 kPa (2.4
kgf/cm
2
or bar, 35 psi) provided that it
does not exceed the maximum cold tire
pressure molded on the tire sidewall.
Wheel size:
16 6 1/2JJ
Wheel nut torque, N
·m (kgf·m, ft·lbf):
103 (10.5, 76)
NOTE: For a complete information on
tires (e.g. replacing tires or re-
placing wheels), see “Checking
tire pressure” through “Aluminum
wheel precautions”, pages 267
through 273, in Section 7−2.
Tires
To Next Page
Loading...
