’03 MATRIX_U (L/O 0201)
206
2003 MY COROLLA MATRIX_U (OM12767U)
3. Remove the wheel ornament.
Pry off the wheel ornament, using the
beveled end of the wheel nut wrench as
shown.
CAUTION
Do not try to pull off the ornament by
hand. Take due care in handling the
ornament to avoid unexpected person-
al injury.
4. Loosen all the wheel nuts.
Always loosen the wheel nuts before rais-
ing the vehicle.
Turn the wheel nuts counterclockwise to
loosen. To get maximum leverage, fit the
wrench to the nut so that the handle is
on the right side, as shown above. Grab
the wrench near the end of the handle
and pull up on the handle. Be careful that
the wrench does not slip off the nut.
Do not remove the nuts yet—just unscrew
them about one−half turn.
5. Position the jack at the correct jack
point as shown.
Make sure the jack is positioned on a
level and solid place.
—Removing wheel ornament
(steel wheels)
—Loosening wheel nuts —Positioning the jack
carownersmanual.net
carownersmanual.net
To Next Page
Loading...
