Toyota 2005 RAV4 - Page 80

Fig. 73: Disassembling No. 2 Hub Sleeve Assembly
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
10. REMOVE INPUT SHAFT FRONT BEARING INNER RACE
Using a screwdriver and hammer, remove the input shaft front bearing inner race.
INSPECTION
1. INSPECT GEAR SYNCHRONIZER RING
a. Check for wear or damage.
b. Check the braking effect of the synchronizer ring. Turn the synchronizer ring in one direction while
pushing it to the gear cone. Check that the ring locks.
If the braking effect is insufficient, apply a small amount of the fine lapping compound between the
s
y
nchronizer rin
g
and
g
ear cone. Li
g
htl
y
rub the s
y
nchronizer rin
g
and
g
ear cone to
g
ether.
2005 Toyota RAV4
2005 TRANSMISSION Manual Transaxle - RAV4
Microsoft
Tuesday, July 21, 2009 9:47:23 AM Page 80 © 2005 Mitchell Repair Information Company, LLC.