EasyManua.ls Logo

Toyota 2006 Sequoia - Wireless Remote Control

Toyota 2006 Sequoia
479 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
06_SEQUOIA_U (L/O 0508)
18
1. “LOCK” switch
2. UNLOCK” switch
3. Back window open switch
4. PANIC” switch
The wireless remote control system is
designed to lock or unlock all the side
doors and back door, open the back
window or activate the “PANIC” mode
from a distance within approximately 1
m (3 ft.) of the vehicle.
When you operate any switch, push it
slowly and securely.
The wireless remote control transmitter is
an electronic component. Observe the fol-
lowing instructions in order not to cause
damage to the transmitter.
! Do not leave the transmitter in places
where the temperature becomes high
such as on the dashboard.
! Do not disassemble it.
! Avoid knocking it hard against other
objects or dropping it.
! Avoid putting it in water.
You can use up to 4 wireless remote con-
trol transmitters for the same vehicle.
Contact your Toyota dealer for detailed
information.
If the wireless remote control transmitter
does not actuate the doors or alarm, or
operate from a normal distance:
! Check for closeness to a radio trans-
mitter such as a radio station or an
airport which can interfere with normal
operation of the transmitter.
! The battery may have been consumed.
Check the battery in the transmitter. To
replace the battery, see “—Replacing
battery” on page 23.
If you lose your transmitter, contact your
Toyota dealer as soon as possible to
avoid the possibility of theft, or an acci-
dent. (See If you lose your wireless re-
mote control transmitter on page 404 in
Section 4.)
Wireless remote control

Table of Contents

Related product manuals