Toyota 2007 Highlander - Page 297

’07 HIGHLANDER HV_U (L/O 0608)
285
2007 HIGHLANDER HV from July ’06 Prod. (OM48685U)
The ceiling mounted garage door opener
motor should now recognize the
HomeLink
#
unit and be able activate the
garage door up/down.
4. Repeat steps 1 through 3 for each re-
maining HomeLink
#
button to program
another rolling code system.
Programming an entrance gate/program-
ming all devices in the Canadian market
1. Decide which of the 3 HomeLink
#
but-
tons you want to program.
2. Place your hand−held gate/device
transmitter 25 to 75 mm (1 to 3 in.)
away from the surface of the
HomeLink
#
.
Keep the indicator light on the HomeLink
#
in view while programming.
3. Press and hold the selected
HomeLink
#
button.
4. Continuously press and release (cycle)
the hand−held gate/device transmitter
button every two seconds until step 5
is complete.
5. When the indicator light on the
HomeLink
#
changes from a slow to a
rapid flash after 20 seconds, you can
release both buttons.
6. Test the operation of the HomeLink
#
by
pressing the newly programmed button.
Check to see if the gate/device oper-
ates correctly.
7. Repeat steps 1 through 6 for each re-
maining HomeLink
#
button to program
another device.
Programming other devices
To program other devices such as home
security systems, home door locks or
lighting, contact your authorized Toyota
dealer for assistance.
Reprogramming a button
Individual HomeLink
#
buttons cannot be
erased, however, to reprogram a single
button, follow the procedure “Programming
the HomeLink
#
”.
(b) Operating the HomeLink
#
To operate the HomeLink
#
, press the
appropriate HomeLink
#
button to activate
the programmed device. The HomeLink
#
indicator light should come on. The
HomeLink
#
continues to send the signal
for up to 20 seconds as long as the
button is pressed.
(c) Erasing the entire HomeLink
#
memory (all three programs)
To erase all previously programmed codes
at one time, press and hold down the 2
outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase
the programs stored in the HomeLink
#
memory.
For additional programming assistance
with your HomeLink
#
Universal
Transceiver call the:
" Toyota Customer Experience Center at
1−800−331−4331 (U.S.A.)
" Toyota Canada Customer Interaction
Centre at 1−888−869−6828 (Canada)